act ttext
Manipulates a number of actuator outputs. These are direct means of switching
on and off various outputs for the control of solenoids and other various
devices on the satellite board(s). Note that this command is designed for
diagnostic purposes only, and not for the regular control of the various air
cylinders. Thus there are come cylinder which require two separate "act"
commands before it will move.
When no parameters are given, a listing of the available outputs and a little
description of each one is displayed.
CAUTION: When moving the Stow and Tilt cylinders manually you MUST lower (extend) Stow first
then Tilt ((tsret off, tret off) then TSEXT ON then ,TTEXT ON ) and when raising table
first retract Tilt then retract Stow ((ttext off, tsext off) then TTRET ON then TSRET ON)
CAUTION: These are "low level" commands, meaning that there are no safety
checks done by the firmware before the command is executed.
Platesetter_3244
act [<output> on|off]